Fe1.1 usb hub controller схема

fe1.1 usb hub controller схема
Consequently, a bus reset or current-limiting switch is often included to account for changing configurations. For requests to copy this content, contact us. APP 5801: Mar 19, 2015 TUTORIAL 5801, AN5801, AN 5801, APP5801, Appnote5801, Appnote 5801. Also, GL850G’s power enable pin supports both high-enable and low-enable power switch that provides better flexibility on component selection.GL850G embeds an 8-bit RISC processor to manipulate the control/status registers and respond to the requests from USB host. Fortunately, almost all of these proprietary dedicated chargers identify themselves by a DC level set on the D+ and D- lines by a resistor-divider between 5V and ground (Figure 2). Figure 2. Dedicated charging ports from a variety of manufacturers. You should also note that the board’s SATA-power connector uses the same polarity as other Orange or Banana Pis.


Please review / rework the information, and remove this reminder when done. Если же при подключении USB-диска блок питания был уже нагружен по другим каналам хаба (до ~0.5A), то диск определяется и подключается. The GL850G is a full function solution which supports both Individual/Gang power management modes and the two-color (green/amber) status LEDs. Please refer the table in the end of this chapter for more detail. Right now, using this tutorial I have a 5v voltage regulator in my schematic to shift the input down to the 5v I need to run the chips. Some of it may be incorrect, or might not apply to this device.

Dedicated Charging Port (DCP) This port does not support any data transfer, but is capable of supplying charge currents beyond 1.5A. It features a short between the D+ and D- lines. The configurability of this class of devices makes host adapter emulators especially suitable for computers. The development process, links to patches and links to kernel fork repositories are listed on the Linux mainlining effort page. Наконец-то удалось организовать монтаж и тестирование опытных образцов устройства новой версии. Даже если у используемого ПК они есть, то сколько качественных (и насколько длинных) кабелей-удлинителей потребуется… А если желательно использовать ноутбук? Кликните на схему, чтобы увеличить Наибольшее внимание в схеме уделено дорабатываемому устройству – хабу-концентратору Konoos UK-26 (в китайском «девичестве» – «4-ports USB 2.0 High Speed Hub»). Задача доработки – обеспечение максимальной надёжности и помехозащищённости.

Похожие записи: